Subaru Crosstrek Service Manual: Security and locks
- Access buzzer
- Access key
- Accessory relay (push button start)
- Body integrated unit
- Door lock control system
- Front door latch and door lock actuator assembly
- Front hood lock assembly
- Front inner remote
- Front outer handle
- Function setting (customize)
- General description
- Ig relay1 (push button start)
- Ig relay2 (push button start)
- Ignition key lock
- Immobilizer antenna
- Impact sensor
- Keyless access cm
- Keyless access indoor antenna
- Keyless access outdoor antenna
- Keyless access system
- Keyless buzzer
- Keyless entry control module
- Keyless entry system
- Keyless transmitter
- Push button ignition switch
- Push button start system
- Rear door latch and door lock actuator assembly
- Rear gate latch and actuator assembly
- Rear gate opener button
- Rear inner remote
- Rear lock button
- Rear outer handle
- Receiver
- Relay and fuse
- Remote openers
- Security control module
- Security system
- Starter cut relay
- Starter relay (push button start)
- Steering lock cm
- Id code box Note
- Immobilizer control module Note
- Key lock cylinders Replacement
- Keyless access with push button start system Diagnostic procedure with phenomenon
Installation
SEATS > Seat Heater SystemINSTALLATIONCAUTION:• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.• When repl ...
Access buzzer
...
Other materials:
Dtc p0724 brake switch "b" circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0724 BRAKE SWITCH "B" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not shifted down when climbing a hill or driving down a hill.C ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSTALLATION1. Install the inhibitor switch to the transmission case temporarily.2. Connect the inhibitor harness connector to the inhibitor switch.3. Install the shifter arm and fix with the spring pin.NOTE:Use new spring pin.(A)Spring ...
Removal
MECHANICAL(H4DO) > V-beltREMOVALNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. V-BELT1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the V-belt covers.(2) Remove the air intake duct. Ai ...
