Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Front Outer Handle
INSPECTION
Check if the outer handle operates normally.
• If the lever is faulty, replace the handle - door outer.
• If the rod is deformed, replace the latch & actuator assembly - front.
For models with keyless access system with push button start, check that the keyless access function operates normally.
If the system does not operate normally, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION">
Removal
SECURITY AND LOCKS > Front Outer HandleREMOVAL1. Raise the glass assembly - front door to the top position.2. Disconnect the ground cable from battery and wait for at least 60 seconds before starti ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission HarnessINSTALLATION1. INHIBITOR HARNESSInstall in the reverse order of removal.NOTE:Install the transmission ground terminal in the direction within the range of approx. 30° (A).Tightening torque:T1: 7 N·m (0.7 kgf-m, 3.7 ...
Dtc p1449 evap system clog detected (air filter)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1449 EVAP SYSTEM CLOG DETECTED (AIR FILTER)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode C ...
