Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Impact Sensor
INSTALLATION
1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.
2. Close all the doors and rear gate.
3. Press the UNLOCK button of the keyless transmitter or access key.
4. Disconnect the ground cable from battery. NOTE">
5. Install the impact sensor.
6. Change the setting of impact sensor using Subaru Select Monitor.
Removal
SECURITY AND LOCKS > Impact SensorREMOVAL1. Pull out the key from the ignition switch, or turn off the power.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitt ...
Operation
SECURITY AND LOCKS > Impact SensorOPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact sensor setting.(1) Connect the Subaru Select Monitor.NOTE:For detailed operation pro ...
Other materials:
Dtc b2779 remote control engine starter collation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2779 REMOTE CONTROL ENGINE STARTER COLLATIONDTC detecting condition:When the keyless access CM does not respond to engine start even when the remote control engine starter is O ...
ECO history screen
Average fuel consumption per unit time
(bar graph)
Average fuel consumption corresponding
to the driving distance of each trip meter
(red line)
This screen displays the fuel economy
history for the vehicle using a bar graph.
The horizontal scale represents the past
time range ...
Low tire pressure warning light (U.S.-spec. models)
When
the ignition switch is turned to the
"ON" position, the low tire pressure warning
light will illuminate for approximately 2
seconds to check that the tire pressure
monitoring system (TPMS) is functioning
properly. If there is no problem and all tires
are properly inflated, the light w ...
