Subaru Crosstrek Service Manual: Operation

1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR

1. Make an impact sensor setting.

(1) Connect the Subaru Select Monitor.

NOTE:

For detailed operation procedures, refer to “Application help”.

(2) Turn the ignition switch to ON.

(3) On «Start» display, select «Diagnosis».

(4) On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

(5) On «Main Menu» display, select «Each System».

(6) On «Select System» display, select «Body Control» and then select «Enter».

(7) On «Select Function» display, select «Customize».

(8) From the Customize item list, select «Impact sensor» or «Impact Sensor Setup».

(9) Make an impact sensor setting.

• When installing: ON

• When removing: OFF

(10) Make an impact sensor ON/OFF setting.

• When installing: ON

• When removing: OFF

(11) Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.

Installation

Keyless access cm

Other materials:

Dtc b2277 submerging circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2277 SUBMERGING CIRCUITDTC detecting condition:When the water-submersion detection circuit integrated into the keyless access CM detects the water submersion.Trouble symptom:&b ...

Removal
REAR SUSPENSION > Front Lateral LinkREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the bolts and nuts, and then remove the trailing link.3. Remove the lateral link assembly - front.(1) Remove the snap pin (a) and nut (b).(2) Remove the ball joint from the housing assembl ...

List
LAN SYSTEM (DIAGNOSTICS) > CAN Communication Circuit CheckLISTResistance value between CAN Hi and LoContents of inspectionRemarksGround short inspection CAN Communication Circuit Check > INSPECTION">Shorted to ground in the communication circuit or control module.Battery short inspecti ...