Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Impact Sensor
REMOVAL
1. Pull out the key from the ignition switch, or turn off the power.
2. Close all the doors and rear gate.
3. Press the UNLOCK button of the keyless transmitter or access key.
4. Disconnect the ground cable from battery. NOTE">
5. Remove the impact sensor.
6. Change the setting of impact sensor using Subaru Select Monitor.
Adjustment
SECURITY AND LOCKS > Impact SensorADJUSTMENT1. CHECK IMPACT SENSOR1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the windows.3. Close all the doors an ...
Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the ...
Other materials:
Caution
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionCAUTION1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when s ...
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT">• Make sure that engine does not start with clutch pedal no ...
Dtc c1561 reverse off fault
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1561 REVERSE OFF FAULTNOTE:For the diagnostic procedure, refer to “DTC C1562 REVERSE ON FAULT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1562 REVERSE ON ...
