Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator Assembly
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">
3. Remove the latch and actuator - rear gate.
(1) Disconnect the connector.
(2) Remove the bolts, and remove the latch and actuator - rear gate.
Inspection
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace ...
Installation
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Refer to “COMPONENT” of “General Descript ...
Other materials:
Dtc c2513 torque sensor much tolerance
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2513 TORQUE SENSOR MUCH TOLERANCENOTE:Refer to “DTC C2511 TORQUE SENSOR MAIN” for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC ...
Treadwear
The treadwear grade is a comparative
rating based on the wear rate of
the tire when tested under controlled
conditions on a specified
government test course.
For example, a tire graded 150
would wear one and one-half (1-
1/2) times as well on the government
course as a tire graded 100.
...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Install the washer and differential bevel gear into the differential case (RH).2. Install the differential bevel pinions into differential case (RH) and install the pinion shaft.(A)Pinio ...
