Subaru Crosstrek Service Manual: Installation

NOTE:

Before installation, remove mud and foreign matter from the caliper body assembly.

1. Before installation, check the rear disc rotor. Rear Disc Rotor > INSPECTION">

2. Install each part in the reverse order of removal.

NOTE:

When installing the rear disc rotor, match the alignment mark (a) of the rear disc rotor and the alignment mark (b) of the bolt - hub.

3. Adjust the parking brake. Parking Brake Assembly (Rear Disc Brake) > ADJUSTMENT">

Tightening torque:

Brake hose bracket: 33 N·m (3.36 kgf-m, 24.3 ft-lb)

Mounting bolt: Refer to “COMPONENT” of “General Description” for the tightening torque. General Description > COMPONENT">

Rear wheel: Except for C4 model

120 N·m (12.24 kgf-m, 88.5 ft-lb)

Rear wheel: C4 model

100 N·m (10.20 kgf-m, 73.8 ft-lb)

Removal

Stop light switch

Other materials:

Dtc u0140 lost communication with body control module
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0140 LOST COMMUNICATION WITH BODY CONTROL MODULEDetected when CAN data from BIU does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROC ...

Push-button ignition switch (models with "keyless access with push-button start system")
Operating range for push-button start system Antennas Operating range NOTE In the Subaru Ascent, the push-button ignition system will function only when the access key fob is detected within the effective operating range of the built-in antennas inside the vehicle. Even if t ...

Removal
LUBRICATION(H4DO) > Engine Oil FilterREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. OIL FILTER1. Turn the ignition switch to OFF.2. Remove the oil filter.NOTE:Clean off water or dust from the oil ...