Subaru Crosstrek Service Manual: Inspection

1. Check the setting by performing Keyless access system check using the Subaru Select Monitor. Keyless Access System Check > OPERATION">

2. Disconnect the Subaru Select Monitor. Operate the touch sensor of the door outer handle to check if door lock operates.

3. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS)” section. General Diagnostic Table > INSPECTION">

Keyless access indoor antenna

Removal

Other materials:

Dtc p0507 idle control system rpm - higher than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0507 IDLE CONTROL SYSTEM RPM - HIGHER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine keeps running at higher speed than specified idl ...

Dtc u0422 invalid data received from body control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF DIAG ...

Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - map. (Models without EyeSight) Spot Map Light > REMOVAL">3. Remove the stereo camera cover assembly. (Models with EyeSight) Stereo ...