Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Access Buzzer
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Lift up the vehicle.
3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.
4. Remove the access buzzer.
(1) Disconnect the connector.
(2) Remove the clip and detach the access buzzer.
Inspection
SECURITY AND LOCKS > Access BuzzerINSPECTIONUsing the Subaru Select Monitor, perform forced operation of the access buzzer. User Customizing > OPERATION">If the buzzer does not sound, r ...
Installation
SECURITY AND LOCKS > Access BuzzerINSTALLATIONInstall each part in the reverse order of removal.CAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a) ...
Other materials:
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...
Dtc p0032 a/f / o2 heater control circuit high bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0032 A/F / O2 HEATER CONTROL CIRCUIT HIGH BANK 1 SENSOR 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...
Dtc b1812 short in driver s airbag dual stage - 2nd step (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1812 SHORT IN DRIVER’S AIRBAG DUAL STAGE - 2ND STEP (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Airbag modu ...
