CLUTCH SYSTEM > Clutch Pipe and Hose
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the clip (A) from the air intake boot.
3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
4. Loosen the clamp (C) which connects the air intake boot and throttle body.

5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

6. Drain the brake fluid. Clutch Fluid">
7. Disconnect the clutch pipe from the clutch hose and master cylinder.
8. Remove the clamp, and then remove the clutch hose.

(A) | Clamp |
(B) | Clutch hose |
9. Disconnect the clutch hose from operating cylinder.
10. Remove the harness clip.

(A) | Harness clip |
(B) | Clutch hose bracket |
11. Remove the clutch hose bracket.
Inspection
InstallationInstallation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSTALLATION1. Install the leak check valve assembly to the vehicle with the bolt and clip (A).Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Connect the connector to the leak check valve assembly.3. Conn ...
Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEDetecting condition:Defective harness connectorTrouble symptom:Communication is impossible between the TPMS & keyless entry CM or TPMS CM and the Subaru Select Monitor.WI ...
Installation
LIGHTING SYSTEM > Combination Switch (Light)INSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do not allow harness and con ...