Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Clutch pipe and hose

Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag ...

Inspection
CLUTCH SYSTEM > Clutch Pipe and HoseINSPECTIONCheck the pipes and hoses for breaks and damage. Check the joint for brake fluid leakage. If crack, breakage or damage is found, repair or replace the ...

Other materials:

Dtc b2285 steering lock position signal correlation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2285 STEERING LOCK POSITION SIGNAL CORRELATIONDTC detecting condition:When the steering lock position signal transmitted from the steering lock CM via solid line and the steeri ...

Removal
EXTERIOR/INTERIOR TRIM > Side GarnishREMOVAL1. Remove the clips and detach the side garnish assembly.(1)Garnish ASSY - fender(2)Garnish ASSY - rear quarter(3)Garnish ASSY - side sill2. Remove the garnish assembly or protector on the fender panel.CAUTION:Do not reuse the garnish assembly and prote ...

Removal
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axle n ...

© 2016-2024 Copyright www.sucross.com