Subaru Crosstrek Service Manual: Installation
CLUTCH SYSTEM > Clutch Pedal
INSTALLATION
1. Install in the reverse order of removal.
CAUTION:
Always use a new clevis pin.
Tightening torque:
Clutch pedal
18 N·m (1.8 kgf-m, 13.3 ft-lb)
Knee airbag module
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Air intake boot
3 N·m (0.3 kgf-m, 2.2 ft-lb)
2. Adjust the clutch pedal after installation. Clutch Pedal > ADJUSTMENT">
3. Check the clutch start system.
Inspection
CLUTCH SYSTEM > Clutch PedalINSPECTIONMove the clutch pedal pads in the lateral direction with a force of approximately 10 N (1 kgf, 2 lbf) to check that the clutch pedal deflection is within the s ...
Other materials:
Dtc b16f2 front sub sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F2 FRONT SUB SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:Front sub sensor (RH) is misinstalled.CAUTION:Before performing diagnosis, refer to “CAUTION&rdqu ...
Dtc b1618 front sub sensor lh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1618 FRONT SUB SENSOR LH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of front sensor bus (LH)• Front sub sensor (LH) is fa ...
Dtc b2222 system microcomputer fail
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2222 SYSTEM MICROCOMPUTER FAILDTC DETECTING CONDITION:When the microcomputer froze.TROUBLE SYMPTOM:MFD does not operate.NOTE:Reset the MFD. If it does not return to the normal operation, replac ...
