Subaru Crosstrek Service Manual: Installation
CLUTCH SYSTEM > Clutch Pipe and Hose
INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed air from brake fluid. Clutch Fluid Air Bleeding">
Tightening torque:
T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
T3: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
(A) | Clutch pipe |
(B) | Clamp |
(C) | Clutch hose |
(D) | Tank hose |
Tightening torque:
Air intake boot
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air ...
Clutch switch
...
Other materials:
Removal
GLASS/WINDOWS/MIRRORS > Power Window Control SwitchREMOVAL1. MAIN SWITCH1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the panel - power window main ...
Malfunction indicator light does not come on
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT COME ONTROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.NOTE:Refer to IDI section for diagnostic procedure. Basic Diagnostic Procedur ...
Dtc c1811 system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1811 SYSTEMDTC detecting condition:ABS and VDC long time sequential controlTrouble symptom:• ABS does not operate.• VDC does not operate.• EBD may not operate.• Hill ...
