Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive Gear

REMOVAL

1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">

2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">

3. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">

4. Remove the extension case assembly.

5. Remove the transfer driven gear.

6. Remove the transfer drive gear.

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearASSEMBLY1. Set the ST against the inner race of the ball bearing, and install the transfer drive gear.CAUTION:Do not apply a load in e ...

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearDISASSEMBLY1. Remove the snap ring.2. Remove the ball bearing. ...

Other materials:

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position Sensor PlateREMOVALThe crankshaft position sensor plate is tightened together with the drive plate or flywheel; therefore, refer to “Drive Plate” or “Flywheel” for removal procedure. Drive Plate > REMOVAL"& ...

Hill start assist warning light does not go off
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternHILL START ASSIST WARNING LIGHT DOES NOT GO OFFDetecting condition:• Defective combination meter• Defective CAN communicationTrouble symptom:Hill start assist warning light does not go off when starting t ...

Caution
IGNITION(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cov ...

© 2016-2025 Copyright www.sucross.com