Always block the wheels under both vehicle and trailer when parking. Apply the parking brake firmly. You should not park on a hill or slope. If parking on a hill or slope cannot be avoided, you should take the following steps: 1. Apply the brakes and hold the pedal down.
2. Have someone place wheel blocks under both the vehicle and trailer wheels.
3. When the wheel blocks are in place, release the regular brakes slowly until the blocks absorb the load.
4. Apply the regular brakes and then apply the parking brake; slowly release the regular brakes.
5. Shift into 1st or reverse gear (MT models) or "P" position (CVT models) and shut off the engine.
Driving on gradesProtector tape Installation
EXTERIOR BODY PANELS > Protector TapeINSTALLATIONApply the protector tape by the following steps.1. REAR QUARTER PROTECTOR (MODELS WITHOUT SIDE GARNISH)(1)Apply the protector tape by aligning it to the rounded edge. 1. Clean the area around applying position to remove any foreign objects on bo ...
Inspection
SECURITY AND LOCKS > ReceiverINSPECTION1. Check if the door lock operates when the touch sensor of the door outer handle and rear lock button is operated.2. If the system does not operate normally as the result of inspection, refer to “General Diagnostic Table” of the “KEYLESS A ...
Installation
EXTERIOR/INTERIOR TRIM > Roof TrimINSTALLATIONCAUTION:• For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION ...