Subaru Crosstrek Owners Manual: Trailer towing tips
CAUTION
- For models equipped with the
BSD (Blind Spot Detection) and
RCTA (Rear Cross Traffic Alert)
driving support systems, when
towing a trailer, press the BSD/
RCTA OFF switch to deactivate
the system. The system may not
operate properly due to the
blocked radar waves. For details
about the BSD/RCTA OFF switch,
refer to "BSD/RCTA OFF switch"
F7-55.
- Never exceed 45 mph (72 km/h)
when towing a trailer in hilly
country on hot days.
- When towing a trailer, steering,
stability, stopping distance and
braking performance will be different
when compared to normal
operation. For safety's sake, you
should employ extra caution
when towing a trailer and you
should never drive at excessive
speeds. You should also keep the
following tips in mind:
- When parking on a steep slope
with a trailer attached to your
vehicle, the braking power of the
parking brake may not be sufficient
since stronger braking
power is needed.
WARNING
Never tow a trailer when the temporary
spare tire is used. The temporary
spare tire is not designed to
sustain the towing load. Use of the
temporary spare tire when towing
can result in ...
Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also ...
Other materials:
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF Cooler (With Warmer Function)INSPECTIONReplace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check that there are no CVTF or engine coolant leaks from the connections.2. Check the clamp for deformation. ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Automatic Transmission AssemblyINSTALLATION1. Attach the ST to converter case.ST 498277200STOPPER SET2. When completely overhauling the transmission, refill CVTF through the transmission right side plug. Preparation for Overhaul">3. Replace ...
Ornament Installation
EXTERIOR/INTERIOR TRIM > OrnamentINSTALLATION1. LETTER MARKAlign the end of application tape with the end of panel, then adhere the letter mark.(a)Panel - rear gate end(b)Application tape end NOTE:• Align the cutout of application tape with the end reference of the front door. (a)• A ...
© 2016-2026 Copyright www.sucross.com
