Subaru Crosstrek Owners Manual: Tires
WARNING
Never tow a trailer when the temporary spare tire is used. The temporary spare tire is not designed to sustain the towing load. Use of the temporary spare tire when towing can result in failure of the spare tire and/or less stability of the vehicle.
Make sure that all the tires on your vehicle are properly inflated. Refer to "Tires" F12- 8.
Trailer tire condition, size, load rating and proper inflation pressure should be in accordance with the trailer manufacturer's specifications. Also check federal, state, province and/or other applicable regulations.
In the event your vehicle gets a flat tire when towing a trailer, ask a commercial road service representative or professional to repair the flat tire.
If you carry a regular size spare tire in your vehicle or trailer as a precaution against getting a flat tire, be sure that the spare tire is firmly secured.
Trailer lights
CAUTION
Direct splicing or other improper
connection of trailer lights may
damage your vehicle's electrical
system and cause a malfunction of
your vehicle's lighting system.
Connection of traile ...
Trailer towing tips
CAUTION
For models equipped with the
BSD (Blind Spot Detection) and
RCTA (Rear Cross Traffic Alert)
driving support systems, when
towing a trailer, press the BSD/
RCTA OFF switch to deac ...
Other materials:
Driving with a trailer
You should allow for considerably more
stopping distance when towing a trailer.
Avoid sudden braking because it may
result in skidding or jackknifing and loss of
control.
Avoid abrupt starts and sudden accelerations.
If your vehicle has a manual
transmission, always start out in ...
Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for OverhaulPROCEDURE1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine stand, follow the instructions of engine stand used.Tightening torque:35 N·m (3.6 kgf-m, 25. ...
Inspection
ENTERTAINMENT > Switches and HarnessINSPECTION1. SATELLITE SWITCH ASSEMBLY1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 2VOL (+)VOL (−)SEEK (›)SEEK (‹)LISTRETURNA circuit is all OFF.Approx. 1 ...
