Subaru Crosstrek Service Manual: Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
Location
CRUISE CONTROL SYSTEM > Relay and Fuse
LOCATION
Relay & fuse box | Fuse 10 A (stop light & brake switch) | (A) |
NOTE:
For other related fuses, refer to the wiring diagram. Power Supply Circuit">
General description
Caution
CRUISE CONTROL SYSTEM > General DescriptionCAUTION• Before disassembling or reassembling parts, always disconnect the battery ground cable from battery. When replacing the audio, con ...
Cruise control command switch
Installation
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Descrip ...
Other materials:
Caution
EyeSight > General DescriptionCAUTION• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyREMOVALNOTE:Always replace primary pulley and secondary pulley as an assembly because they are non-disassembled parts.1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL& ...
Clear memory mode Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATIONAfter repairing the occupant detection system, clear the DTCs stored in the airbag control module and the occupant detection control module.1. AIRBAG SYSTEM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» ...
