Subaru Crosstrek Service Manual: Cruise control command switch
Installation
CRUISE CONTROL SYSTEM > Cruise Control Command Switch
INSTALLATION
CAUTION:
• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
• Do not allow harness and connectors to interfere or get tangled up with other parts.
• If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
1. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT">
2. Install each part in the reverse order of removal.
NOTE:
Align the alignment marks on the steering wheel and the column assembly - steering.
Tightening torque:
Steering wheel: 39 N·m (3.98 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in)
Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check ...
Cruise control system
Note
CRUISE CONTROL SYSTEM > Cruise Control SystemNOTEFor operation procedures of each component of the cruise control system, refer to the respective section.• Control module: Control Unit ...
Other materials:
Dtc b1900 short in front p/t rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1900 SHORT IN FRONT P/T RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (RH) circuit is shorted.• Pretensioner (RH) is faulty.• Pretensioner harness ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorINSPECTION1. Check that the engine oil temperature sensor has no deformation, cracks or other damages.2. Immerse the engine oil temperature sensor and a thermometer in water.CAUTION:Take care not to allow water to get into the eng ...
Brake line Inspection
PERIODIC MAINTENANCE SERVICES > Brake LineINSPECTION1. BRAKE LINE1. Check for scratches, swelling, corrosion, traces of fluid leakage on the brake hoses or pipe joints.2. Make sure that brake pipes/hoses do not interfere with adjacent parts and there is no loose connector/clamp during driving.3. ...
