CRUISE CONTROL SYSTEM > Cruise Control System
NOTE
For operation procedures of each component of the cruise control system, refer to the respective section.
• Control module: Control Unit">
NOTE:
System control of the cruise control is performed by each module. For procedure, refer to the following sections.
– Engine control module (ECM): Engine Control Module (ECM)">
– Transmission control module (TCM): Transmission Control Module (TCM)">
• Cruise control command switch: Cruise Control Command Switch">
• Combination meter: Combination Meter">
• Stop light and brake switch: Stop Light Switch">
• Clutch switch: Clutch Switch">
• Inhibitor switch: Inhibitor Switch">
• Neutral position switch: Switches and Harness">
CRUISE CONTROL SYSTEM > General Description
LOCATION
Refer to “LOCATION” of “CRUISE CONTROL SYSTEM (DIAGNOSTICS)” section. Electrical Component Location > LOCATION">
Inspection
CONTROL SYSTEMS > Select CableINSPECTIONCheck the removed cable and replace or adjust if damaged, rusty or malfunctioning.1. Check the cable for smooth operation.2. Check the inner cable for damage and rust.3. Check the outer cable for damage, bends and cracks.4. Check the boot for damage, cracks ...
To arm the system using the keyless access function (if equipped)
1. Close all windows and the moonroof (if
equipped)
2. Turn the push-button ignition switch to
the "OFF" position.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close all doors and the rear gate.
Door lock sensor
Security i ...
Transfer driven gear Note
TRANSFER CASE > Transfer Driven GearNOTEFor removal, installation and inspection, refer to “CVT” or “5MT” section.CVT model: Transfer Driven Gear">5MT model: Transfer Driven Gear"> ...