Subaru Crosstrek Service Manual: Caution
EyeSight > General Description
CAUTION
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable.
• Be careful of the following items. Failing to do so may cause the airbag system malfunction.
– Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION">
– Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform the VDC setting mode. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">
• If the damage is found in the glass repair prohibited area, always replace the glass. General Description > INSPECTION">
Damage in the prohibited area can affect the recognition of the stereo camera even if it is repaired, and thereby EyeSight function may not operate properly.
Preparation tool
EyeSight > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS87599VA000RANDOM CHARTUsed for adjusting stereo camera. — SUBARU SELECT MONITOR 4Used for set ...
Other materials:
Removal
INTAKE (INDUCTION)(H4DO) > Air Intake BootREMOVAL1. Remove the clip (A) from the air intake boot.2. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.3. Loosen the clamp (C) which secures the throttle body to the air intake boot.4. Disconnect the PCV hose and remove ...
Dtc b1825 short in side airbag lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1825 SHORT IN SIDE AIRBAG LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is shorted.• Side airbag module (LH) is faulty.• Airbag control ...
Dtc u0073 control module communication bus off
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDiagnosis start condition:Ignition voltage remains at 10 V or more for 1 second.DTC detecting condition:Detected when malfunction occurs in CAN line.NOTE:Perform the diagnosis for LAN sys ...
