Subaru Crosstrek Service Manual: Eyesight
- Eyesight system
- General description
- Relay and fuse
- Stereo camera
- Switches and harness
- Body integrated unit Note
- Camera adjustment, inspection Procedure
- Combination meter Note
- Control unit Note
- Diagnostics with phenomenon Inspection
- Multi-function display (mfd) Note
- Roll connector Note
- Stop light brake switch Note
- Transmission control module (tcm) Note
- Vdc control module and hydraulic control unit (vdccm h/u) Note
Real-time diagnosis Operation
EyeSight (DIAGNOSTICS) > Real-time DiagnosisOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed» ...
Eyesight system
...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
Removal
STARTING/CHARGING SYSTEMS(H4DO) > StarterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.4. Loosen the clamp (C) which secures the throttle body t ...
Caution
DRIVE SHAFT SYSTEM > General DescriptionCAUTION• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.• Remove contamination including dirt and corrosion before removal, installation, di ...
