Subaru Crosstrek Service Manual: Vdc control module and hydraulic control unit (vdccm h/u) Note
EyeSight > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)
NOTE
For the operation procedures for VDC control module & hydraulic control module (VDCCM&H/U), refer to “VEHICLE DYNAMICS CONTROL (VDC)” section. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
Transmission control module (tcm) Note
EyeSight > Transmission Control Module (TCM)NOTEFor the operation procedures for transmission control module (TCM), refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. Transmission ...
Front suspension
...
Other materials:
Drive cycle Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Drive CyclePROCEDUREIt is necessary to perform the drive cycle listed below if DTC is not found in the Inspection Mode. It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cyc ...
Component
DRIVE SHAFT SYSTEM > General DescriptionCOMPONENT1. PROPELLER SHAFT(1)Propeller shaft(3)Rear differential (T-type)Tightening torque: N·m (kgf-m, ft-lb)(2)Rear differential (VA1-type) T1:31 (3.2, 22.9) T2:52 (5.3, 38.4)2. FRONT AXLE• EBJ + PTJ type(1)Circlip(8)Boot (PTJ)(15)Front ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearINSTALLATION1. Install the transfer drive gear.Tightening torque:26 N·m (2.7 kgf-m, 19.2 ft-lb)2. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION">3. Install the transfer driven ...
