Subaru Crosstrek Service Manual: Inspection

Replace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.

1. Check that there are no CVTF or engine coolant leaks from the connections.

2. Check the clamp for deformation.

3. Lightly bend the CVTF cooler hose and check for cracks in the surface or other damages.

4. Pinch the CVTF cooler hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was installed by pressing with your fingernail.

5. Check for peeling, cracks, and deformation at the tip of the hose.

6. Check the CVTF cooler (with warmer feature) for any damage.

Disassembly

Installation

Other materials:

Dtc c0072 abnormal yaw rate sensor output
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0072 ABNORMAL YAW RATE SENSOR OUTPUTDTC DETECTING CONDITION:Defective yaw rate sensorTROUBLE SYMPTOM:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.INTERVIEW ...

Dtc b14e6 mode door actuator stepping motor circuit short-circuit
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E6 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT SHORT-CIRCUITDTC detecting condition:Mode door actuator stepping motor circuit is shorted.Trouble symptom:Vent does not change.Wiring diagram:Air condi ...

Dtc p2196 a/f /o2 sensor signal biased/stuck rich bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2196 A/F /O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...