Subaru Crosstrek Service Manual: Installation

1. Install the CVTF cooler (with warmer feature) to the transmission.

Tightening torque:

23 N·m (2.3 kgf-m, 17.0 ft-lb)

2. Install the engine coolant inlet hose.

NOTE:

With the triangle mark on the engine coolant inlet hose facing the vehicle outside, install the hose to the EGR cooler.

3. Install the CVTF inlet hose and CVTF outlet hose to transmission.

NOTE:

Use the new CVTF inlet hose and CVTF outlet hose.

4. Connect the engine coolant outlet hose.

5. Check installation condition of each hose.

• Make sure the hoses do not interfere with each other or with other components.

• Check each hose for bent, excess curve, and twisting conditions.

6. Install the engine hanger rear.

Tightening torque:

21 N·m (2.1 kgf-m, 15.5 ft-lb)

7. Connect the EGR control valve harness connector, throttle position sensor harness connector and manifold absolute pressure sensor harness connector.

8. Connect the engine harness connectors, then install the harness connector bracket.

Tightening torque:

7.5 N·m (0.8 kgf-m, 5.5 ft-lb)

9. Install the air intake boot assembly. Air Intake Boot > INSTALLATION">

10. Connect the battery ground terminal.

11. Fill engine coolant. Engine Coolant > REPLACEMENT">

12. Adjust the CVTF level. CVTF > ADJUSTMENT">

Inspection

Cvtf filter

Other materials:

Ground circuit Wiring diagram
WIRING SYSTEM > Ground CircuitWIRING DIAGRAM ...

Installation
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSTALLATION1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENT">NOTE:After pulling out the drive shaft assembly, be sure to replace with a new oil seal.2. Insert the drive shaft assembly into the rear hub ...

Removal
EXTERIOR/INTERIOR TRIM > Roof RailREMOVAL1. Remove the trim panel - roof. Roof Trim > REMOVAL">2. Remove the curtain airbag module. Curtain Airbag Module > REMOVAL">CAUTION:• Before handling the airbag system components, refer to “CAUTION” of “Gener ...