Subaru Crosstrek Service Manual: Real-time diagnosis Operation
EyeSight (DIAGNOSTICS) > Real-time Diagnosis
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «EyeSight» and select «Enter».
5. On «Select Function» display, select «Data Monitor».
6. Check that the display changes and the contents are correct when performing the operations as follows.
• Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
– Item «Brake Lamp SW (BIU)» «Brake SW Input» «Brake Lamp SW (VDC)»
• Turn the main switch to ON.
– Item «Cruise Control SW Voltage (Port14)» and «Cruise Control SW Voltage (Port16)»
• Turn the “SET/−” switch to ON.
– Item «Cruise Control SW Voltage (Port14)» and «Cruise Control SW Voltage (Port16)»
• Turn the “RES/+” switch to ON.
– Item «Cruise Control SW Voltage (Port14)» and «Cruise Control SW Voltage (Port16)»
• Turn the “Vehicle distance” switch to ON.
– Item «Cruise Control SW Voltage (Port14)» and «Cruise Control SW Voltage (Port16)»
• Operate the shift lever.
– Item «Current gear position»
• Press and hold the pre-collision brake OFF switch.
– Item «Pre-Collision Brake OFF Indicator»
• Press and hold the lane departure warning OFF switch.
– Item «Lane Departure Warning OFF Indicator»
NOTE:
For detailed operation procedures, refer to “Application help”.
Read current data Operation
EyeSight (DIAGNOSTICS) > Read Current DataOPERATION1. STEREO CAMERA1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select ...
Eyesight
...
Other materials:
Oil pressure warning light
If
this light illuminates when the engine is
running, it may indicate that the engine oil
pressure is low and the lubricating system
is not working properly.
If the light illuminates while driving or does
not turn off after the engine starts, stop the
engine at the first safe opportunity ...
Control screen and audio panel
Control screen
Perform the SXM setting. See below.
Refer to "SXM setting" F5-42.
Search for a channel which the
direction of higher frequency from
current frequency. Reproduce the
channel that can receive by 5
seconds.
A list is displayed. There are three
types of lists ("P ...
Trailer towing tips
CAUTION
For models equipped with the
BSD (Blind Spot Detection) and
RCTA (Rear Cross Traffic Alert)
driving support systems, when
towing a trailer, press the BSD/
RCTA OFF switch to deactivate
the system. The system may not
operate properly due to the
blocked radar waves. For det ...
