Subaru Crosstrek Service Manual: Note
EyeSight > EyeSight System
NOTE
For procedure of each component in the EyeSight system, refer to the respective section.
• Control module: Control Unit">
NOTE:
System control of the EyeSight is performed by each module. For procedure, refer to the following sections.
– Engine control module (ECM): Engine Control Module (ECM)">
– Transmission control module (TCM): Transmission Control Module (TCM)">
– VDC control module & hydraulic control unit (VDCCM&H/U): VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">
– Stereo camera: Stereo Camera">
– Body integrated unit: Body Integrated Unit">
• Combination meter: Combination Meter">
• Stop light and brake switch: Stop Light Switch">
• Multi-function display (MFD): Multi-function Display (MFD)">
• Switches and harness: Switches and Harness">
• Roll connector (steering angle sensor): Roll Connector">
Wiring diagram
EyeSight > EyeSight SystemWIRING DIAGRAMRefer to “EyeSight System” in the wiring diagram. EyeSight System > WIRING DIAGRAM"> ...
Other materials:
Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailurePROCEDURE1. Check of the fuel amount↓2. Inspection of starter motor circuit Diagnostics for Engine Starting Failure > STARTER MOTOR CIRCUIT">↓3. Inspection of ECM power supply and ground line Diagnostics fo ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > FRESH/RECIRC Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the FRESH/RECIRC switch to check that the link operates normally.3. If it does not operate normally as t ...
