ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting Failure
PROCEDURE
1. Check of the fuel amount |
↓ |
2. Inspection of starter motor circuit Diagnostics for Engine Starting Failure > STARTER MOTOR CIRCUIT"> |
↓ |
3. Inspection of ECM power supply and ground line Diagnostics for Engine Starting Failure > CHECK POWER SUPPLY AND GROUND LINE OF ENGINE CONTROL MODULE (ECM)"> |
↓ |
4. Inspection of ignition control system Diagnostics for Engine Starting Failure > IGNITION CONTROL SYSTEM"> |
↓ |
5. Inspection of fuel pump circuit Diagnostics for Engine Starting Failure > FUEL PUMP CIRCUIT"> |
↓ |
6. Inspection of fuel injector circuit Diagnostics for Engine Starting Failure > FUEL INJECTOR CIRCUIT"> |
Starter motor circuit
Ignition control systemDtc b2285 steering lock position signal correlation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2285 STEERING LOCK POSITION SIGNAL CORRELATIONDTC detecting condition:When the steering lock position signal transmitted from the steering lock CM via solid line and the steeri ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeINSTALLATION1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4. ...
Dtc u0416 invalid data received from vehicle dynamics control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUT ...