Subaru Crosstrek Service Manual: Wiring diagram
EyeSight > EyeSight System
WIRING DIAGRAM
Refer to “EyeSight System” in the wiring diagram. EyeSight System > WIRING DIAGRAM">
Inspection
EyeSight > EyeSight SystemINSPECTIONRefer to “Basic Diagnostic Procedure” of “EyeSight (DIAGNOSTICS)” section. Basic Diagnostic Procedure"> ...
Note
EyeSight > EyeSight SystemNOTEFor procedure of each component in the EyeSight system, refer to the respective section.• Control module: Control Unit">NOTE:System control of the EyeSi ...
Other materials:
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyINSTALLATION1. Install the leak check valve assembly to the vehicle with the bolt and clip (A).Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Connect the connector to the leak check valve assembly.3. Conn ...
Dtc u0100 lost communication with ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF DIA ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.&bul ...
