Subaru Crosstrek Service Manual: Inspection
EyeSight > Relay and Fuse
INSPECTION
1. CHECK FUSE
1. Remove the fuse and inspect visually.
2. If the fuse is blown out, replace the fuse.
NOTE:
If the fuse is blown again, check the system wiring harness.
2. CHECK RELAY
1. Measure the resistance between relay terminals.
Terminal No. | Inspection conditions | Standard | Circuit |
1 — 2 | Always | 1 M? or more |
1 — 4
Always
Less than 1 ?
1 — 2
Apply battery voltage between terminals 3 and 5.
Less than 1 ?
2. Replace the relay if the inspection result is not within the standard value.
Relay and fuse
...
Location
EyeSight > Relay and FuseLOCATIONRelay & fuse boxFuse 10 A (stop light and brake switch, brake light relay)(A)Relay holderBrake light relay(B)NOTE:For other related fuses, refer to the wiring d ...
Other materials:
Removal
EXTERIOR BODY PANELS > Front DoorREMOVAL1. FRONT DOOR PANEL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the sealing cover - front door. Front Sea ...
Terms
Packet write
This is a general term that describes
the process of writing data on-demand to
CD-R, etc., in the same way that data is
written to floppy or hard discs.
ID3 tag
This is a method of embedding trackrelated
information in an MP3 file. This
embedded information can incl ...
Dtc p1451 evap system clog detected (pipe)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1451 EVAP SYSTEM CLOG DETECTED (PIPE)DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear M ...
