Subaru Crosstrek Service Manual: Dtc p1451 evap system clog detected (pipe)

DTC DETECTING CONDITION:

Detected when two consecutive driving cycles with fault occur.

CAUTION:

After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, and Inspection Mode Inspection Mode > PROCEDURE">.

1.CHECK DRAIN TUBE BETWEEN CANISTER AND LEAK CHECK VALVE ASSEMBLY.

Is the drain tube between canister and leak check valve assembly clogged?

Replace the drain tube between the canister and leak check valve assembly. Canister">

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1451 EVAP SYSTEM CLOG DETECTED (PIPE)">Go to Step 2.

2.CHECK HOSES BETWEEN CANISTER AND FUEL TANK.

Are the hoses between the canister and fuel tank clogged?

Replace the hoses between the canister and fuel tank. Canister"> Fuel Tank">

Replace the canister. Canister">

After the operation is complete, go to the next step. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1451 EVAP SYSTEM CLOG DETECTED (PIPE)">Go to Step 3.

3.CHECK EVAPORATIVE EMISSION CONTROL SYSTEM.

Perform drive cycle I. Drive Cycle > PROCEDURE">

Is DTC P1451 displayed on the display?

Replace the leak check valve assembly. Leak Check Valve Assembly">

End.

For the detection standard, refer to DTC P0455. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0455 EVAP SYSTEM (CPC) LEAK DETECTED (LARGE LEAK)">

Dtc p1449 evap system clog detected (air filter)

Dtc p1492 coil 1 egr "a" control circuit low

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchINSTALLATION1. Install the thrust bearing.NOTE:Make sure to install in the right direction.2. Install the transfer clutch assembly.3. Select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">4. Attach the selected t ...

Removal
STARTING/CHARGING SYSTEMS(H4DO) > BatteryREMOVAL1. Disconnect the positive (+) terminal after disconnecting the negative (−) terminal of battery.2. Remove the battery cable holder from the battery rod.3. Remove the flange nut from battery rod and remove battery holder.4. Remove the battery. ...

PIN Code Access (models with "keyless access with push-button start system")
Rear lock button While all doors (including the rear gate) are locked, you can unlock the doors (including the rear gate) without a key by pressing the rear lock button. NOTE PIN Code Access will be helpful if the key is accidentally left in the vehicle. It is recommended that a 5-d ...