Subaru Crosstrek Service Manual: Combination meter Note
EyeSight > Combination Meter
NOTE
For the operation procedures for combination meter, refer to “INSTRUMENTATION/DRIVER INFO” section. Combination Meter">
Camera adjustment, inspection Procedure
EyeSight > Camera Adjustment, InspectionPROCEDURECAUTION:• Perform the camera adjustment and inspection at curb weight without passengers.• Handle RANDOM CHART (ST) carefully so as not ...
Control unit Note
EyeSight > Control UnitNOTESystem control of the EyeSight is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine Control Module (EC ...
Other materials:
Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, sele ...
Installation
DRIVE SHAFT SYSTEM > Rear AxleINSTALLATION1. Temporarily tighten the rear axle housing to the upper arm assembly.2. Install the rear drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the h ...
