Subaru Crosstrek Service Manual: Roll connector Note
EyeSight > Roll Connector
NOTE
For the operation procedures for roll connector (steering angle sensor), refer to “AIRBAG SYSTEM” section. Roll Connector">
Multi-function display (mfd) Note
EyeSight > Multi-function Display (MFD)NOTEFor the operation procedures for Multi-Function Display (MFD), refer to “INSTRUMENTATION/DRIVER INFO” section. Multi-function Display (MFD)&q ...
Stop light brake switch Note
EyeSight > Stop Light & Brake SwitchNOTEFor the operation procedures for stop light and brake switch, refer to “BRAKE” section. Stop Light Switch"> ...
Other materials:
Operation
EyeSight (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. GENERAL DESCRIPTIONFor on-board diagnosis function of the EyeSight, use the Subaru Select Monitor.The on-board diagnosis function operates in three categories, which are used depending on the type of problems.1. Diagnosis with diagnostic t ...
Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...
Connecting and disconnecting a USB memory/portable device
The USB port and the AUX jack are
located as shown in the following illustration.
NOTE
This unit does not support commercially
available USB hubs.
Turn on the power of the device
when it is not turned on.
This device has a USB port for USB
memory/portable device.
For compatible ...
