Subaru Crosstrek Owners Manual: All-Wheel Drive warning light (CVT models)
This
light blinks if the vehicle is driven with
tires of differing diameters fitted on the
wheels or with an excessively low air
pressure in any of the tires.
WARNING
If the AWD warning light flashes, promptly park in a safe location then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason.
Continuing to drive with the AWD warning light flashing can lead to powertrain damage.
Door open warning light
The
warning light illuminates if any door
(including the rear gate) is not fully closed.
This function is effective even if the
ignition switch is in the "LOCK"/"OFF" or
"ACC" position, or t ...
Power steering warning light
This
warning light illuminates when the
ignition switch is turned to the "ON"
position and turns off after the engine
has started. This indicates that the warning
system is working properly.
...
Other materials:
Basic inspection
WIRING SYSTEM > Basic Diagnostic ProcedureBASIC INSPECTION1. VOLTAGE MEASUREMENT1. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal and the positive lead to the connector or component terminal.2. Contact the positive lead of the voltmeter on connect ...
Removal
EXTERIOR/INTERIOR TRIM > Roof SpoilerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the roof spoiler assembly.(1) Disconnect the connector of high-mounted stop light.(2) Remove the caps, ...
Disassembly
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldDISASSEMBLY1. Remove the throttle body. Throttle Body > REMOVAL">2. Remove the purge control solenoid valve. Purge Control Solenoid Valve > REMOVAL">3. Remove the manifold absolute pressure sensor. Manifold Absolute Pre ...
