The
warning light illuminates if any door
(including the rear gate) is not fully closed.
This function is effective even if the ignition switch is in the "LOCK"/"OFF" or "ACC" position, or the key is removed from the ignition switch.
Always make sure this light is not illuminated before you start to drive.
Current date and time setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
" switch to
select the "Time/Date" item. Then push
the
button.
3. Select the item to set by operating the
"
" or "
" switch. Then push the
button.
...
Removal
WIPER AND WASHER SYSTEMS > Rear WasherREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR.(1) Remove the claws on the trim edge.(2) Release the claws in the center of trim, and remove the trim panel - rear gate UPR.3. Remove the roof spoiler ...
Dtc c0023 front left abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0023 FRONT LEFT ABS SENSOR CIRCUIT OPEN OR SHORTNOTE:For the diagnostic procedure, refer to “DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORT”. Diagnostic Procedure with Dia ...