Subaru Crosstrek Owners Manual: Warning and indicator lights
- Initial illumination for system check
- Seatbelt warning light and chime
- SRS airbag system warning light
- Front passenger's frontal airbag ON and OFF indicators
- Check engine warning light/Malfunction indicator light
- Coolant temperature low indicator light/Coolant temperature high warning light
- Charge warning light
- Oil pressure warning light
- Engine low oil level warning light
- At oil temp warning light (CVT models)
- Low tire pressure warning light (U.S.-spec. models)
- ABS warning light
- Brake system warning light (red)
- Low fuel warning light
- Hill start assist warning light/Hill start assist OFF indicator light
- Door open warning light
- All-Wheel Drive warning light (CVT models)
- Power steering warning light
- Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light
- Vehicle Dynamics Control OFF indicator light
- Warning chimes and warning indicator of the keyless access with push-button start system (if equipped)
- Security indicator light
- Select lever/gear position indicator (CVT models)
- Cruise control indicator light (if equipped)
- Automatic headlight beam leveler warning light (models with HID headlights)
- Headlight indicator light
- Steering responsive fog lights warning indicator/ Steering responsive fog lights OFF indicator (models with EyeSight system)
ECO gauge (if equipped)
U.S.-spec. models
Except U.S.-spec. models
The ECO gauge shows the difference
between the current rate of fuel consumption
and the average rate of fuel consumption
since the trip meter ...
Initial illumination for system check
Several of the warning and indicator lights
illuminate when the ignition switch is
initially turned to the "ON" position. This
permits checking the operation of the
bulbs.
Apply the parking bra ...
Other materials:
Component
IGNITION(H4DO) > General DescriptionCOMPONENT(1)Spark plug(2)Ignition coilTightening torque: N·m (kgf-m, ft-lb) T1:8.5 (0.9, 6.3) T2:17.5 (1.8, 12.9) ...
Disassembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterDISASSEMBLYCAUTION:The starter should be placed through a no-load test whenever it has been overhauled.1. Disconnect the cable from the magnet switch assembly.2. Remove the magnet switch assembly from the starter housing assembly.3. Remove screws (A) of th ...
Preparation tool
INSTRUMENTATION/DRIVER INFO > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer ...
