Subaru Crosstrek Owners Manual: Vehicle Dynamics Control OFF indicator light
The
light illuminates when the Vehicle
Dynamics Control OFF switch is pressed
to deactivate the Vehicle Dynamics Control
system.
The Vehicle Dynamics Control system is probably malfunctioning under any of the following conditions. Have your vehicle checked at a SUBARU dealer immediately.
- The light does not illuminate when the ignition switch is turned to the "ON" position.
- The light does not turn off even once several seconds have elapsed after the ignition switch has been turned to the "ON" position.
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
The light may remain illuminated for
a short perio ...
Warning chimes and warning indicator of the keyless access with push-button
start system (if equipped)
Access key warning indicator (type A)
Access key warning indicator (type B)
The warning chime and the access key
warning indicator are used for the following
purposes.
Minimizing impro ...
Other materials:
Dtc u0101 lost communication with tcm
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...
Operation
ENTERTAINMENT > Telematics SystemOPERATION1. REGISTRATION (COMM CHECK)CAUTION:Because it will go back to Factory mode when the signal is weak, that you do not press the i button more than 2 seconds during a communication check. If it had returned to Factory mode, carrying out the CommCheck again. ...
Removal
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove all clips.3. Remove the lock assembly - front hood.(1) Remove the bolt and clip.(2) Disconnect the rel ...
