Subaru Crosstrek Owners Manual: Initial illumination for system check
Several of the warning and indicator lights illuminate when the ignition switch is initially turned to the "ON" position. This permits checking the operation of the bulbs.
Apply the parking brake and turn the ignition switch to the "ON" position. For the system check, the following lights illuminate and then turn off after several seconds or after the engine has started.
Seatbelt
warning light
(The seatbelt warning light turns off
only when the driver fastens the
seatbelt.)
:
Front passenger's seatbelt warning
light
(The seatbelt warning light turns off
only when the front seat passenger
fastens the seatbelt.)
SRS
airbag system warning light
Front
passenger's frontal airbag
ON indicator light
Front
passenger's frontal airbag
OFF indicator light
CHECK
ENGINE warning light/Malfunction
indicator light
Coolant
temperature low indicator
light/Coolant temperature high warning
light
Charge
warning light
Oil
pressure warning light
Engine
low oil level warning light
(models with type A combination
meter)
Windshield
washer fluid warning light
(models with type A combination
meter)
AT
OIL TEMP warning light
(CVT models)
Low
tire pressure warning light
(U.S.- spec. models)
ABS
warning light
Brake
system warning light
Low
fuel warning light
Hill
start assist warning light/Hill start
assist OFF indicator light
Door
open warning light
AWD
warning light (CVT models)
Power
steering warning light
Vehicle
Dynamics Control warning
light/Vehicle Dynamics Control operation
indicator light
Vehicle
Dynamics Control OFF indicator
light
Automatic
headlight beam leveler
warning light (models with HID headlights)
If any lights fail to illuminate, it indicates a burned-out bulb or a malfunction of the corresponding system.
Consult your authorized SUBARU dealer for repair.
Seatbelt warning light and chime
Your
vehicle is equipped with a seatbelt
warning device at the driver's and front
passenger's seat, as required by current
safety standards.
With the ignition switch turned to the "ON"
posi ...
Other materials:
Removal
ENTERTAINMENT > External Connection TerminalREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the console box assembly. Console Box > REMOVAL">3. While pressing the claw, press it in from the rear to remo ...
Dtc u0424 invalid data received from hvac control module
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0424 INVALID DATA RECEIVED FROM HVAC CONTROL MODULENOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">1. OUTLINE OF DIAGN ...
Ventilator control
Center ventilators
Center ventilators
In the Subaru Ascent, the center ventilators are designed to provide flexible
airflow control for front occupants. To adjust the direction of airflow, move the
control tab to the desired angle. If you need to stop airflow completely, move the
tab fu ...
