Subaru Crosstrek Owners Manual: Security indicator light
This indicator light shows the status of the alarm system. It also indicates operation of the immobilizer system.
Alarm system
It blinks to show the driver the operational status of the alarm system. For detailed information, refer to "Alarm system"
Immobilizer system
The security indicator light starts blinking in the following conditions.
For models with "keyless access with push-button start system":
Immediately after the push-button ignition switch is turned to the "OFF" position.
Immediately after the driver's door is opened or closed when all of the following conditions are met.
- The push-button ignition switch is in the "ON" or "ACC" position.
- The access key is outside the vehicle.
- The engine is not running.
In the event that the push-button ignition switch is pressed to turn it on or to start the engine carrying an unauthorized key (for example, the key is unregistered or the ID code does not match), the power is not switched to "ON" and the security indicator light continues blinking.
For models without "keyless access with push-button start system":
- Approximately 60 seconds after the ignition switch is turned from the "ON" position to the "ACC" or "LOCK" position.
- Immediately after the key is pulled out.
If the indicator light does not blink in the above conditions, it may indicate that immobilizer system may be malfunctioning.
Contact your nearest SUBARU dealer immediately.
In the event that an unauthorized key (for example, an unauthorized duplicate) is used to start the engine, the security indicator light illuminates. For details about the immobilizer system, refer to "Immobilizer"
NOTE
The security indicator light remains off in the following conditions. This is normal and does not indicate a malfunction.
- while the engine is running
- for approximately 60 seconds after the ignition switch is turned from the "ON" position to the "ACC" or "LOCK"/"OFF" position
Even if the security indicator light blinks irregularly or its fuse blows (the light does not blink if its fuse is blown), the immobilizer system will function normally.
Warning chimes and warning indicator of the keyless access with push-button
start system (if equipped)
Access key warning indicator (type A)
Access key warning indicator (type B)
The warning chime and the access key
warning indicator are used for the following
purposes.
Minimizing impro ...
Select lever/gear position indicator (CVT models)
Type A
Upshift indicator
Downshift indicator
Select lever/gear position indicator
Type B
Upshift indicator
Downshift indicator
Select lever/gear position indicator
This i ...
Other materials:
Dome light and cargo area light
Dome light
Cargo area light
1. Remove the lens by prying the edge of
the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Other bulbs
It may be difficult to replace the bulbs.
Have the bulbs replaced by your
...
Control screen
PHONE (Menu) screen
PHONE (Dialpad) screen
Open the "Incoming Calls" screen.
Refer to "By incoming calls"
Open the "Outgoing Calls" screen.
Refer to "By outgoing calls"
Open the "Contacts" screen. Refer to
"By contacts list
Open the dialpad screen. Refer to "By
Dialpad
O ...
Removal
COMMUNICATION SYSTEM > HornREMOVALCAUTION:Do not remove the bumper face - front when removing the horn, in order to prevent damaging the claws of the bracket - front bumper corner and the bracket - front bumper side.1. Disconnect the ground cable from battery. NOTE">2. Remove the clip, a ...
