Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Shift lock release using the shift lock release button

Perform the following procedure to release the shift lock.

1. Apply the parking brake and turn the ignition switch to the "LOCK"/"OFF" position.

Shift lock release using the shift lock release button

2. Wrap the tip of a flat-head screwdriver with vinyl tape or a cloth and use it to remove the shift lock cover. The shift lock release button is located under the shift lock cover.

Shift lock release using the shift lock release button

3. While depressing the brake pedal, insert a screwdriver into the hole, press the shift lock release button using a screwdriver, and then move the select lever.

If the select lever does not move after performing the above procedure, the shift lock system may be malfunctioning. Contact a SUBARU dealer for an inspection as soon as possible.

Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the "ON" position then move the select lever to the "P" position with the select lever button pressed and brake pedal depre ...

Driving tips
Always apply the foot or parking brake when the vehicle is stopped in the "D" or "R" position. Make sure to apply the parking brake when parking your vehicle. Do not hold the vehicle with ...

Other materials:

Assembly
BRAKE > Master CylinderASSEMBLYCAUTION:When replacing the reservoir tank, adhere the label to the position shown in the figure. (C5 model)Preparation items:C5 modelPart No.: Label (25080GA010)(a)Label(b)Brake booster 1. Install the seal to the cylinder body assembly.2. Install the reservoir tank ...

Active test Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active TestOPERATIONCAUTION:• Be sure to perform the active test while the engine is not running.• After executing the active test, execute the Clear Memory Mode.1. On «Start» display, select «Diagnosis».2. On «Vehicle selection ...

Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveINSTALLATIONCAUTION:Replace the O-rings with new parts, and then apply compressor oil.1. Install each part in the reverse order of removal.Tightening torque:Heater and cooling unit: General Description > COMPONENT">Air conditio ...

© 2016-2026 Copyright www.sucross.com