Subaru Crosstrek Owners Manual: Shift lock function
The shift lock function helps prevent the improper operation of the select lever.
- The select lever cannot be operated unless the ignition switch is turned to the "ON" position and the brake pedal is depressed.
- The select lever cannot be moved from
the "P" position to any other position
before the brake pedal is depressed.
Depress the brake pedal first, and then operate the select lever.
- Only the "P" position allows you to turn the ignition switch from the "ACC" position to the "LOCK"/"OFF" position and remove the key from the ignition switch.
- If the ignition switch is turned to the "LOCK"/"OFF" position while the select lever is in the "N" position, the select lever may not be moved to the "P" position after a period of time. Therefore, move the select lever to the "P" position with the brake pedal depressed soon after the ignition switch is turned to the "LOCK"/ "OFF" position.
Selection of manual mode
With the vehicle either moving or stationary,
move the select lever from the "D"
position to the "M" position to select the
manual mode.
Type A
Upshift indicator
Downshift indicator
...
Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the "ON"
position then move the select lever to the
"P" position with the select lever button
pressed and brake pedal depre ...
Other materials:
Inspection
STARTING/CHARGING SYSTEMS(H4DO) > GeneratorINSPECTION1. DIODECAUTION:There is the possibility of damaging the diodes if a mega-tester (used to measure high voltages) or a similar measuring instrument is used. Never use a mega tester or equivalent for this test.1. Check for continuity between the ...
Dtc c1561 reverse off fault
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1561 REVERSE OFF FAULTNOTE:For the diagnostic procedure, refer to “DTC C1562 REVERSE ON FAULT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1562 REVERSE ON ...
Assembly
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldASSEMBLY1. Install the fuel pipe and cap to the intake manifold.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the fuel delivery pipe to the intake manifold.CAUTION:• Check that there is no damage or dust on the quick c ...
