Subaru Crosstrek Owners Manual: Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the "ON" position then move the select lever to the "P" position with the select lever button pressed and brake pedal depressed.
If the select lever does not move after performing the above procedure, perform the following steps.
- When the select lever cannot be shifted from "P" to "N": Refer to "Shift lock release using the shift lock release button" F7-28.
- When the select lever cannot be shifted from "N" to "R", "P": Within 60 seconds after placing the ignition switch in the "ACC" position, move the select lever to the "P" position with the select lever button pressed and brake pedal depressed.
If you must perform the above procedure, the shift lock system (or the vehicle control system) may be malfunctioning. Contact a SUBARU dealer for an inspection as soon as possible.
If the select lever does not move after performing the above procedure, refer to "Shift lock release using the shift lock release button" F7-28.
Shift lock function
The shift lock function helps prevent the
improper operation of the select lever.
The select lever cannot be operated
unless the ignition switch is turned to the
"ON" position and the brake p ...
Shift lock release using the shift lock release button
Perform the following procedure to release
the shift lock.
1. Apply the parking brake and turn the
ignition switch to the "LOCK"/"OFF" position.
2. Wrap the tip of a flat-head screwdriver
w ...
Other materials:
Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the ...
Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...
Anniversary setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
" switch to
select the "Anniversary" item. Then push
the
button.
3. Select an entry in the list to set by
operating the "
"
or "
"
switch. Then
push the ...
