CAUTION
The access key contains electronic components. Observe the following precautions to prevent malfunctions or battery discharge
If the access key gets wet, wipe it off immediately and let it dry completely.
NOTE
After the vehicle battery is discharged or replaced, initialization of the steering lock system may be required to start the engine. In this case, perform the following procedure to initialize the steering lock.
1) Turn the push-button ignition switch to the "OFF" position. For details, refer to "Switching power status" 3-7.
2) Open and close the driver's door.
3) Wait for approximately 10 seconds.
When the steering is locked, the initialization is completed.
Regarding radio wave
Regarding access keyDtc c0032 fr pressure reducing valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0032 FR PRESSURE REDUCING VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “DTC C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Troub ...
List of diagnostic trouble code (dtc) List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContentReferenceU0073CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION ...
Installation
EXTERIOR BODY PANELS > Rear DoorINSTALLATION1. REAR DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - rear door on it.2. Apply grease to the moving part of door hinges.3. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hing ...