Subaru Crosstrek Owners Manual: Keys and doors
- Keys
- Immobilizer
- Door locks
- Locking and unlocking from the outside
- Locking and unlocking from the inside
- Battery drainage prevention function
- Power door locking switches
- Keyless access with push-button start system (if equipped)
- Access key
- Safety precautions
- Locking and unlocking with "keyless access" entry function
- Selecting audible signal operation
- Warning chimes and warning indicator
- Disabling keyless access function
- Certification for keyless access with push-button start system
- PIN Code Access (models with "keyless access with push-button start system")
- Remote keyless entry system
- Locking the doors
- Unlocking the doors
- Vehicle finder function
- Sounding a panic alarm
- Selecting audible signal operation (models without "keyless access with push-button start system")
- Replacing lost transmitters
- Certification for remote keyless entry system
- Alarm system
- System operation
- Activating and deactivating the alarm system
- If you have accidentally triggered the alarm system
- Arming the system
- Disarming the system
- Valet mode
- Passive arming (models without "keyless access with push-button start system")
- Tripped sensor identification
- Shock sensors (dealer option)
- Child safety locks
- Windows
- Rear gate
- Moonroof (if equipped)
Precautions against vehicle modification
WARNING
To avoid accidental activation of the
system or rendering the system
inoperative, which may result in
serious injury, no modifications
should be made to any components
or wiring of the S ...
Keys
NOTE
For models with "keyless access with
push-button start system", refer to
"Keyless access with push-button start
system" 2-9.
Master key
Submaster key
Sub key
Key number plate
...
Other materials:
Inspection
SEATS > Seat Heater SystemINSPECTION1. WIRING DIAGRAMRefer to “Seat Heater System” in the wiring diagram. Seat Heater System > WIRING DIAGRAM">2. DIAGNOSTIC CHARTSymptomsRepair orderSeat heater does not operate.1. Check the fuse. Seat Heater System > INSPECTION"&g ...
Inspection
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - front.2. Check the motor operation when battery voltage is applied between terminals of the motor - front connector.• LH sideTerminal No.Inspection conditionsStandard4 (+) — 1 (& ...
Specification
INSTRUMENTATION/DRIVER INFO > General DescriptionSPECIFICATION1. COMBINATION METER ASSEMBLYNOTE:Specifications of the combination meter vary depending on the market and the grade.• Model with normal meterMeter, displayOperation method, display methodDrive controlWhen checking the indicator ...
