Subaru Crosstrek Owners Manual: Warning chimes and warning indicator
The warning chime and the access key warning indicator are used for the following purposes.
- Minimizing improper operations when using the keyless access with push-button start system
- Helping protect your vehicle from theft
For details, refer to "Warning chimes and warning indicator of the keyless access with push-button start system" 3-25.
Selecting audible signal operation
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off. For more details,
contact a SUBARU dealer.
N ...
Disabling keyless access function
WARNING
If you wear an implanted pacemaker
or an implanted defibrillator, perform
the procedure described in
"By operating the driver's door"
2-18 to disable the keyless access
function. If you ...
Other materials:
Dtc p0776 pressure control solenoid "b" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0776 PRESSURE CONTROL SOLENOID "B" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine spe ...
Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp ...
Handling of radar sensors
Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
CAUTION
To ensure correct operation of the
BSD/RCTA, observe the following
precautions.
Always keep the bumper surface
near the radar sensors clean
Do not affix any stickers o ...
