Subaru Crosstrek Owners Manual: Keyless access with push-button start system (if equipped)
The keyless access with push-button start system allows you to perform the following functions when you are carrying the access key.
- Locking and unlocking of the doors and rear gate
- Starting and stopping the engine. For detailed information, refer to "Starting and stopping engine (models with push-button start system)" 7-11.
- Arming and disarming the alarm system.
For detailed information, refer to "Alarm system" 2-26.
Locking and unlocking by the remote keyless entry system can also be controlled with the buttons on the access key.
For detailed information, refer to "Remote keyless entry system" 2-22.
- Access key
- Safety precautions
- Locking and unlocking with "keyless access" entry function
- Selecting audible signal operation
- Warning chimes and warning indicator
- Disabling keyless access function
- Certification for keyless access with push-button start system
Power door locking switches
Lock
Unlock
All doors and the rear gate can be locked
and unlocked by the power door locking
switches located at the driver's side and
the front passenger's side doors.
To lock the d ...
Access key
Access key (main)
Access key (sub)
Key number plate
The vehicle has two access keys and a
key number plate. For details about the
key number plate, refer to "Key number
plate" 2-3.
A ...
Other materials:
Fuel gauge
Fuel gauge (type A)
Trip knob
Fuel gauge (type B)
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
The fuel gauge is displayed when the
ignition is in the "ON" position, and it
shows the approximate amount of fuel
remaining in the tank.
The gauge indic ...
Installation
WIPER AND WASHER SYSTEMS > Washer Tank and MotorINSTALLATION1. Install each part in the reverse order of removal.CAUTION:• Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - fr ...
Removal
LIGHTING SYSTEM > Front Fog Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the screw and clips, and turn over the front side of the mud guard - front.3. From the bottom of the bumper face - front, remove the front fog light bulb.CAUTION:Use a dry clean clot ...
