Subaru Crosstrek Owners Manual: Certification for keyless access with push-button start system
U.S.-spec. models
FCC ID: HYQ14AHC
FCC ID: HYQ13CZZ
FCC ID: Y8PSSPIMB02
FCC ID: Y8PSSPLF02
CAUTION
FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Canada-spec. models
- Mexico-spec. models
Enabling functions
When the procedure to disable the functions
is performed again, a chirp sound will
be heard, and the functions are enabled.
NOTE
The keyless access function will be
enabled only if you perfor ...
PIN Code Access (models with "keyless access with push-button start system")
Rear lock button
While all doors (including the rear gate)
are locked, you can unlock the doors
(including the rear gate) without a key by
pressing the rear lock button.
NOTE
PIN Code A ...
Other materials:
Installation
CLUTCH SYSTEM > Release Bearing and LeverINSTALLATIONNOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main shaft spline• Contact surface of rele ...
Dtc b1830 short in curtain airbag rh squib circuit
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1830 SHORT IN CURTAIN AIRBAG RH SQUIB CIRCUITDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag harness (RH) circuit is shorted.• Curtain airbag module (RH) is faulty. ...
Installation
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSTALLATION1. Replace the rear differential side oil seal. Rear Differential Side Oil Seal > REPLACEMENT">NOTE:After pulling out the drive shaft assembly, be sure to replace with a new oil seal.2. Insert the drive shaft assembly into the rear hub ...
