Subaru Crosstrek Service Manual: Caution
SPEED CONTROL SYSTEMS(H4DO) > General Description
CAUTION
• Prior to starting work, pay special attention to the following:
1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.
2. Protect the vehicle using a seat cover, fender cover, etc.
3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.
• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.
• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
• Keep the removed parts in order and protect them from dust and dirt.
• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc.
• Bolts, nuts and washers should be replaced with new parts as required.
• Be sure to tighten the fasteners including bolts and nuts to the specified torque.
Specification
SPEED CONTROL SYSTEMS(H4DO) > General DescriptionSPECIFICATIONAccelerator pedalStrokeAt pedal pad50 — 59 mm (1.97 — 2.32 in) ...
Other materials:
Installation
LUBRICATION(H4DO) > Oil PanINSTALLATION1. OIL PAN1. Apply liquid gasket to the mating surface of the oil pan upper as shown in the figure, and install the oil pan.NOTE:• Before applying liquid gasket, degrease the old liquid gasket seal surface of the oil pan and the oil pan upper.• U ...
Installation
SECURITY AND LOCKS > Impact SensorINSTALLATION1. Pull out the key from the ignition switch, or turn the ignition switch to OFF.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. In ...
Dtc p2751 intermediate shaft speed sensor "c" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2751 INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shifting shock is felt.• Acceler ...
