Subaru Crosstrek Service Manual: General description

Installation

SPEED CONTROL SYSTEMS(H4DO) > Accelerator PedalINSTALLATIONInstall in the reverse order of removal.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb) ...

Caution

SPEED CONTROL SYSTEMS(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additio ...

Other materials:

Engine oil
For the checking, adding and replacing procedure or other details, refer to "Engine oil" F11-8. NOTE The procedure for changing the engine oil and oil filter should be performed by a properly-trained expert. It is recommended that you have this service performed by your SUBARU dealer. Approv ...

Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerREMOVAL1. Disconnect the ground cable from battery.2. Drain engine coolant. Engine Coolant > REPLACEMENT">3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">4. Lower the vehicle.5. Remove the ...

Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...