Subaru Crosstrek Service Manual: Assembly
DRIVE SHAFT SYSTEM > Rear Axle
ASSEMBLY
1. BUSHING - REAR AXLE HOUSING
Do not remove the bushing - rear axle housing from the rear axle housing, because it cannot be replaced. If removed, replace the rear axle housing.
2. REAR BUSHING
1. Before assembly, inspect the following items and replace any faulty part with a new one.
• Perform visual check for damage or bend on the trailing link.
• Visually check the bushing for abnormal cracks, fatigue or damage.
2. Press-fit the bushing using ST and the hydraulic press.
CAUTION:
Make sure to press the bushing straight in.
Preparation tool:
ST1: BUSHING REMOVER (20099FG000)
ST2: INSTALLER & REMOVER (BASE) (20099PA010)
(1) | Rear bushing | (2) | Rear axle housing |
Rear axle
...
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen ...
Other materials:
Dtc b2789 id code box communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2789 ID CODE BOX COMMUNICATIONDTC detecting condition:• When communication between keyless access CM and ID code box is interrupted for a set amount of time.• Open ...
Specification
TELEMATICS SYSTEM (DIAGNOSTICS) > Control Module I/O SignalSPECIFICATION1. DATA COMMUNICATION MODULE (DCM)Terminal No.ContentMeasuring conditionStandardA1 — — — A2 — — — A3LED GREEN — — A4 ←> Chassis groundi-buttoni-button OFF > ON1.6 k? or more > less than 1 ?A ...
Dtc c1252 wheel speed sensor signal of one of the wheels
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1252 WHEEL SPEED SENSOR SIGNAL OF ONE OF THE WHEELSDTC detecting condition:• Defective ABS wheel speed sensor signal (noise, irregular signal, etc.)• Defective magnetic encoder&b ...
